New industry Technology regarding to Bussmann fuse, ABB breakers, Amphenol connectors, HPS transformers, etc.

Time：2022-05-26 Author：ABPower Browse：

High speed fuse selection calculator:

Fuse Rated voltage refers to the ac sine wave voltage that fuse can withstand when it breaks. The selection follows the following principles: Fuse rated voltage is greater than no-load voltage of rectifying transformer.

The rated voltage of the high speed fuse U_{FU} is determined by the following formula:

U_{fu}>K_{b}U_{2}= 1180 * 1.05 = 1239 V

Take U_{fu}= 1250 V

In this calculating formula:

U_{fu}-- Rated voltage of high speed fuse

U_{2}-- Valve side voltage=1180V

K_{b}-- Network pressure rise coefficient, generally =1.05

The selection of fuse rated current follows the following principles:

(1) Fuse rated current is generally the root mean square value of AC/DC Circuit, which is proved by the temperature rise test and repeatable load test specified in the corresponding standard;

(2) Consider the influence of load current value, installation conditions and ambient temperature;

(3) Avoid load current and external short-circuit current, and check according to the overload capacity curve provided by the high speed fuse manufacturer.

The rated current of the high speed fuse Ifu is determined by the following formula:

Ifu>I_{F(AV) * K}_{i *K}_{a* F}

In this current calculating formula:

Ifu-- Rated current of fast melting

IF(AV)-- The actual average current flowing, Here IF(AV)= 123.4AMP

Ki -- Current margin coefficient, usually 1.2

Ka-- Environmental temperature coefficient, usually 1.1

F -- Waveform coefficient, 3.46

Calculated: =564AMP

Considering the surrounding conditions, connection conditions, overload current, etc., the selection is as follows:

The rectifier high speed fuse ratings are selected as 630A/1250V.

(4) Verification of high speed fuse

I^{2}T value accounting

The I^{2}T value of high speed fuse is calculated as follows:

(I^{2}T)R<= 0.9 I^{2}_{FSM}t

In this formula:

(I2T)R -- the metling T-value of high speed fuse, refer to the high speed fuse manual:

7.3×105A^{2}s, 19×105A2s, 27.5×105A2s

IFSM-- Diode surge current peak

T -- Half cycle time for diode to withstand surge current, 10ms

All the empirical calculations meet the requirements of the above formula.

TAG: high speed fuse dc fuse fast acting fuse fast blown fuse bussmann fuse

Recommend

Bussmann fuse catalogue
Where Eaton Bussmann fuse manufactured?-China
A Solar Energy Power Plant Accident Analysis
500VDC EV fuse from Bussmann
How DC fuse and breaker work in DC system?
Photovoltaic system why and how photovoltaic fuse is used?
Photovoltaic 1500VDC fuse cross reference (NH type)
How to tell a Bussmann 170M fuse genuine or fake?
1500VDC fuse in energy storage
NH fuse cross reference( Bussmann, ABB, Siemens, SIBA)
Medium voltage fuse cross reference
Huawei electric vehicle technology
1000VDC Bussmann fuse in DC fast EV charging station
DC circuit over-current protection fuse and overload protection fuse?
What is DC semiconductor fuse vs AC semiconductor fuse?